[Cialug] Trying to label 2TB USB drive from Redhat 5.7

[Scott Prader]

What type of disklabel is the drive using?

-Scott
On Mar 20, 2014 5:26 PM, "John Lengeling" <john.lengeling at gmail.com> wrote:

> Trying access and label a 2TB portable USB drive under Redhat 5.7.
>
> Normally this just "works" but in this case, the kernel says it is going to
> use sdd1, but none of the device entries exists.
>
> Output from dmesg:
>
> usb 2-1.1: new high speed USB device using ehci_hcd and address 9
> usb 2-1.1: configuration #1 chosen from 1 choice
> scsi25 : SCSI emulation for USB Mass Storage devices
> usb-storage: device found at 9
> usb-storage: waiting for device to settle before scanning
>   Vendor: TOSHIBA   Model: External USB 3.0  Rev: 0201
>   Type:   Direct-Access                      ANSI SCSI revision: 06
> SCSI device sdd: 3907029160 512-byte hdwr sectors (2000399 MB)
> sdd: Write Protect is off
> sdd: Mode Sense: 2b 00 00 00
> sdd: assuming drive cache: write through
> SCSI device sdd: 3907029160 512-byte hdwr sectors (2000399 MB)
> sdd: Write Protect is off
> sdd: Mode Sense: 2b 00 00 00
> sdd: assuming drive cache: write through
>  sdd: sdd1
> sd 25:0:0:0: Attached scsi disk sdd
> sd 25:0:0:0: Attached scsi generic sg4 type 0
>
> /dev entries:
>
> sh-3.2# ls -l /dev/sd*
> brw-r----- 1 root disk 8,  0 Jan 20  2013 /dev/sda
> brw-r----- 1 root disk 8,  1 Jan 20  2013 /dev/sda1
> brw-r----- 1 root disk 8,  2 Jan 20  2013 /dev/sda2
> brw-r----- 1 root disk 8, 16 Jan 20  2013 /dev/sdb
> brw-r----- 1 root disk 8, 32 Jan 20  2013 /dev/sdc
>
> So why isn't udev creating the device entries?
> _______________________________________________
> Cialug mailing list
> Cialug at cialug.org
> http://cialug.org/mailman/listinfo/cialug
>